Setting

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.

If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with the "No signal" message appears on the screen to start the countdown. The countdown time can be set between 1 and 30 minutes with the Point 7 8 buttons.

When the countdown time has been elapsed, the lamp will be turned off to cool itself down. The POWER indicator is blinking red during the cooling-off period. When the lamp has been fully cooled down, the projector operates according to the selected mode.

Ready . . . . . . . The POWER indicator changes to green blinking. In this condition, the projection lamp can be turned on when the input signal is reconnected or any button on the top control or remote control is pressed.

Shutdown . . . . The power will be turned off.

Off . . . . . . . . . The Power management function is off.

On start

When this function is “On,” the projector is automatically turned on just by connecting the AC power cord to an AC outlet.

Note:

Be sure to turn off the projector properly. (See “Turning Off the Projector” on page 18). If the projector is turned off in an incorrect sequence, such as disconnecting the AC power cord before completing the cool-down etc., the On start function does not operate properly.

Lamp mode

This function allows you to change brightness of the screen.

Normal . . . . normal brightness.

Auto . . . . . . brightness according to the input signal.

Eco . . . . . . . . lower brightness that reduces the lamp power consumption and extends the lamp life.

Dim mode

This function allows you to dim the projection screen contrast and brightness. Adjust the contrast level of the Dim mode screen with the Point 7 8 buttons to your desired brightness. (From 0 to 15.) (p22)

Power management

Time left until Lamp off

Press the SELECT button at Power management and this box appears. Choose one of three settings with the Point 78 buttons, and go to the timer with the Point ed buttons and set time with the Point 78 buttons.

Press the Point 78 buttons to adjust the value.

Setting

41

Page 41
Image 41
Eiki LC-SD15 owner manual Power management, On start, Lamp mode, Dim mode