ELAN Home Systems manual Rack Mounting, DT22 INSTALLATION MANUAL, Equipment Rack, Page

DT22 INSTALLATION MANUAL E L A N H O M E S Y S T E M S

Rack Mounting

When mounting the DT22 Tuner in an equipment rack, use the included Rack Mount Brackets for secure mounting and proper ventilation. The DT22 requires two rack spaces.

To install the DT22 into a standard 19” equipment rack:

1. Slide the rack mount brackets onto the DT22 chassis from the front as shown in Figure 14-1.

2.Ensure that the brackets are flush with the front of the unit. Install each of the eight screws (included) through the side mounting flanges into the holes in the sides of the unit as shown in Figure 14-2. Hand tighten screws! Over-tightening could cause damage to the DT22 Tuner.

3.Once the brackets are securely mounted, install the entire assembly into a standard 19” equipment rack from the front using four rack screws (not included). Two rack spaces will be used. See Figure 14-3.

19" Equipment Rack

Rack Screws

Page 14 © ELAN Home Systems 2009 • All rights reserved.