DT22 INSTALLATION MANUAL | E L A N H O M E S Y S T E M S |
This response will also be sent as unsolicited feedback.
Response:
*DT,R1,STEREO,ON<cr>
*DT,R1,STEREO,OFF<cr>
Appendix C: Connecting Optional SIRIUS Tuner Modules
Connecting the Sirius tuner module to the DT22/DT11
1)Refer to the instructions included with the Sirius tuner module (sold separately) for detailed installation information.
2)Connect the Sirius tuner module to the DT22/11 using the 8 pin DIN cable supplied with the tuner.
Displaying the signal strength meter
Using the front panel buttons;
1)Turn the unit on by depressing the TUNER button for 2 seconds.
2)Select Sirius Tuner 1 by pressing the TUNER button.
3)Press and hold MODE button for 2 seconds.
4)Press ENTER to select Signal Details.
5)Satellite and Terrestrial signal strength bar graphs are displayed.
6)Adjust antenna for maximum signal levels.
7)Repeat process above for Sirius Tuner 2 (DT22 only).
Connecting RCA outputs to system
See the diagram on page 16
A note about activation of the tuner
SIRIUS Radio is a subscription service and each tuner must be activated. Tune your SIRIUS radio to station 184 and then;
Call
Contact SIRIUS on the Internet at: https://activate.siriusradio.com/
You’ll need a credit card and the SIRIUS tuner module ID(s) you wish to activate. The 12 digit tuner ID can be found on the tuner module, module packaging or by tuning to channel 0.
|
|
Page 72 | © ELAN Home Systems 2009 • All rights reserved. |
