DT22 INSTALLATION MANUAL | E L A N H O M E S Y S T E M S |
For outdoor installation or indoor wall mounting:
The antenna can also be attached vertically to an external or internal wall if that is more convenient than placing it on a horizontal surface.
a)Holding your antenna up, find a wall location that ensures a strong signal.
b)Attach antenna to the wall using four screws.
c)Tilt the antenna fully back on the base, place the antenna base on the four screw heads with the antenna pivot at the top, and pull down approximately 1/4 inch until the base is firmly secured. Note that the SIRIUS logo will be upside down when the antenna is properly installed.
d)Tilt the antenna away from the wall/base until the signal strength is optimized.
4.Power on your sound system and turn the amplifier to a low volume.
5.Power on DT22 and tune to channel 184, a free preview channel.
If the system is working, you will hear SIRIUS programming on this channel and can proceed to Step 6.
If there is a problem with the antenna connection, the DT22’s front panel display will read “Antenna Error”. If the antenna does not have a clear path to the satellites, the front panel display will read “Acquiring Signal”. Reposition the antenna until you hear music playing.
6.Finish installing DT22.
a)House DT22 in its permanent location. Follow the instructions in the section, “Appendix B: Rack Mounting”.
b)Activate the unit following the “Activating SIRIUS radio” instructions.
Rear Panel Power Switch
The DT22 master power switch is located on the rear panel. The switch must be in the ON position to allow the tuner to operate. To reduce power consumption when away for extended periods of time, set the master switch to
the OFF position. To return tuner to normal operation, set the switch to the ON position.
Rear Panel Power Switch
Operation
The DT22 provides intuitive control of its various functions via its front panel buttons (as shown on the next page), from ELAN Touch Panels and Olé Touchpads, the remote control, and its hard wired IR input. The DT22 is essen- tially two completely independent
From the interface within each zone you can:
•Change channels (either by preset or direct tuning)
•View RDS information (on supported panels)
|
|
Page 22 | © ELAN Home Systems 2009 • All rights reserved. |