ELAN Home Systems DT22 manual AM Loop Antenna, Indoor FM Antenna

E L A N H O M E S Y S T E M S DT22 INSTALLATION MANUAL

AM Loop Antenna

DT22

AM Loop Antenna

The AM antenna is connected to the terminals marked AM/GND. These connections are not polarity sensitive, so it does not matter which wire is connected to the GND or AM terminals.

To prevent unwanted noise, place the antenna as far away as possible from other electronics, speaker cords, power cords and amplifiers.

FM Antenna

DT22-240

REAR PANEL

F-JACK

Indoor FM Antenna

F-CONNECTOR

Connect the included FM antenna to the FM (coaxial) jack. Generally, a T-type twin lead antenna will be sufficient; if you live in an area where the FM signals are particularly weak, it may be necessary to install an outside or rooftop antenna.

If standard FM broadcast frequencies are available via your cable service, you may connect your 75 ohm FM anten- na jack to your cable system. Please contact your cable service to discuss this option.

© ELAN Home Systems 2009 • All rights reserved. Page 19