6. Slide the interface card along the slots on both sides of the interface
compartment. Push it in firmly to fully insert the con nector at the rear
of the interface card into the printer’s internal socket.
7. Secure the interface card in the slot with the two screws included with
the interface card.
8. Connect the proper interface cable to the interface card and to your
computer. If the cable has a grounding wire, connect it with one of
the screws securing the parallel interface.
Also, if you are using more than one computer, reconnect the other
interface cable .
9. Make sure the printer is turned off. Then plug in the power cord.
Before you use the optional interface, you may need to change the settings
for the interface option in the default-setting mode. If you need to change
any settings, see “Changing the default setting.” in Chapter 8 for
instructions.
To remove the interface card, follow the above steps in reverse order.
n102
LLoire2 Ref. Guide
Rev.C
A5 size Appendix B
11-11-96 DR, pass 0
B-4 Using Optional Interfaces