EPSON Stylus COLOR 3000
4.1.3 Head Voltage Write OperationThis operation is performed to write the printhead drive voltages in the EEPROM. You need to perform this operation whenever you replace the printhead.
1.Connect the printer and the host computer with a parallel interface cable.
2.Run the adjustment program in the host computer.
3.Perform “Market Setting” . (Refer to Section 4.1.2.)
4.Move the cursor using − or ↓ key to select “2. Adjustment & Check from the Main menu. Then press “Return” key, and the Adjustment & Check menu appears.
5.Move the cursor using − or ↓ key to select “1. VH, EEPROM” and press “Return” key to enter the menu.
<<<Adjustment and Check>>> | Head Voltage Marked Here. |
| |
0.Market (001) |
|
1.VH, EEPROM |
|
2.Angle Adjustment |
|
3.Vertical Adjustment |
|
4.Gap |
|
| |
| |
7.A4 *1 |
|
8.A3 *2 |
|
Return |
|
Select | Figure |
*1: To print an A4 check pattern, set the paper portrait. |
|
*2: To print an A3 check pattern, set the paper landscape. |
|
6.Write the black head ID (head voltage), which is composed of 5 digits, as shown below. (Refer to Section 4.1.3.1 for details.)
<1. VH, EEPROM>
BK VH 18216
YMC VH 16215
7.Press one of the following keys:
[SPACE] | Retry the operation. |
[0]Quit the menu and return to the Adjustment and Check menu.
[RETURN] | Enter the initial ink charge mode and return to the Adjustment and Check menu. |
[ESC] | Return to the Adjustment Check menu without changing the current values. |
8.Perform one of the following:
Select R.Return using − or ↓ key to and press “Return” key to return to the Main menu.
Select other adjustments using − or ↓ key to and press “Return” key to make the selected adjustment. (Select R.Return using − or ↓ key to and press “Return” key to return to the main menu when all necessary adjustments are done.)
9.Move the cursor using − or ↓ key to select “END and press “Return” key to exit the adjustment program.
WORK POINT
Adjusted values are not stored in the EEPROM until the printer is turned off. Therefore be sure to turn off the printer once after the adjustment program is executed.
The set values are transferred to the printer when this operation is executed. Therefore do not turn off the printer before exiting “VH, EEPROM”.
Rev. A |