Epson 3000 6.3 Lubrication and Adhesive, No, Type, Content, Quantity, Part code, Reference, Product name, Applicability, Lubrication Points

EPSON Stylus COLOR 3000

6.3 Lubrication and Adhesive

Use of lubricant and adhesive has a considerable affect on the performance and durability of the printer. Especially, lubrication at low temperatures requires appropriate selection of the lubricant. Therefore, be sure to apply adequate lubricant and adhesive specified by EPSON based on the analysis of technical information and result from the experimental use of lubricants and adhesives in wide range. Note the followings:

￿Clean the lubrication point before lubricating.

￿Lubricate the printer periodically according to the specification.

￿Additional cleaning is also needed after cleaning, disassembling and assembling the printer.

￿Adhere the specified parts when assembling the printer or replacing the parts. Be sure to use adequate amount of adhesive and dry it thoroughly since overflow of surplus adhesive may cause malfunction to nearby parts.

CAUTION

The lubricants and adhesives specified for this printer are selected based on the evaluation on the condition that they are used for this printer. Therefore never apply items which are not listed since use of other items may result in short printer life and poor printer performance.

Table 6- 1. Recommended Lubricants

Type	Product name	Content	Part code	Applicability
Grease	G-26	40 g	B702600001	EPSON-exclusive product
Oil	O-8	40 g	1019753	EPSON-exclusive product
Adhesive	NEJI lock B1401B	1000 g	B730200200	EPSON-exclusive product

Table 6- 2. Lubrication Points and Application

Reference	Lubrication Points	Quantity
No.
1	Front paper guide assembly	G-26 (3-5 g)
	– Installation sockets for PF roller and paper eject roller
	– Mounting shaft for the gear (11.5)
2	Shaft in the paper eject roller assembly	G-26 (3-5 g)
3	Paper eject drive unit	G-26 (3-5 g)
	– Points where the PR roller shaft slides.
4	Base frame assembly	G-26 (3-5 g)
	– Installation hole where the tractor release shaft is inserted
	– 5 points where the tractor release shaft slides
5	Base frame assembly	G-26 (3-5 g)
	– Contact points with the CR motor unit
6	2 oil pads in the CR unit and the CR shaft	O-8
		(0.63 - 0.65 ml)
7	CR guide shaft	O-8
		￿￿￿￿￿￿￿ ￿￿￿ ￿￿￿￿￿￿ ￿￿￿￿ ￿￿￿
		￿￿￿￿￿ ￿￿￿￿￿ ￿￿￿￿￿￿￿￿
8	Slope on the tractor release cam	G-26 (3-5 g)
9	8 points on the top edge of the paper eject frame	G-26 (10-20g)

Rev. A 6-3