Product Descriptions

￿Panel Functions (Normal Usage)

 

Table 1-28. Panel Functions

 

 

 

 

Button

Function

Available

Comment

Condition

 

 

 

 

 

 

 

Operate

Power On/Off

Always

At turning the printer off, the printer executes

capping function before the power down.

 

 

 

Pause

Pause/Non-Pause

Always

 

Pause

Reset

Pause/Standby

The function will be recognized with this

(5 seconds)

button held down for more than3 seconds.

 

 

LF/FF

LF/FF

Pause/Standby

 

Load/Eject

Load/Eject

Pause/Standby

 

−

Micro adjust

Pause/Standby

See Note below.

Micro Adjust

(Forward feed)

 

 

Micro Adjust

Micro adjust

Pause/Standby

See Note below.

↓

(Reverse feed)

 

 

Cleaning (Black)

Cleaning (Black)

Pause/Standby

The function will be recognized with this

(3 seconds)

button held down for more than 2 seconds.

 

 

Cleaning (Color)

Cleaning (Color)

Pause/Standby

The function will be recognized with this

(3 seconds)

button held down for more than 2 seconds.

 

 

Media Type

Selects paper type.

Pause/Standby

 

Note) TOF (Top Of Form) adjustment

When ”Micro adjust” is executed for the TOF position, the adjusted TOF position is memorized in the EEPROM. TOF positions for the ASF, manual insertion and tractor are stored in the corresponding addresses of EEPROM.

Tear off adjustment

When “Micro adjust” is executed for the tear off position, the adjusted tear off position is memorized in the EEPROM.

￿Panel Functions with Power OnTable 1-29. Panel Function with Power On

Button

Function

Comment

 

 

 

Pause

Enters the printer adjustment mode.

Refer to Section 1.5.3.

LF/FF

Enters LQ self-test print mode.

Refer to Section 1.5.5.

Load/Eject

Enters draft-self test print mode.

Refer to Section 1.5.5.

Media type

Enters the default setting mode.

Refer to Section 1.5.2.

LF/FF

Enters the hex-dump mode.

Refer to Section 1.5.6

+

 

 

Load/Eject

 

 

Pause

Performs EEPROM and IC reset.

Initializes Timer IC and a part of

+

 

the EEPROM.

LF/FF

 

 

+

 

 

Micro adjust ↓

 

 

Note) ”+” means to press one button while holding down the other button(s).

CAUTION

￿The power switch is connected to the secondary side of the electrical circuit. Since it has a delay circuit, voltage is still applied for the specified period of time after the printer power is turned off.

￿As long as the printer is plugged in, voltage is applied to the primary side of the electrical circuit. Therefore be sure to unplug the printer before servicing or replacing the interface.

￿When the EEPROM is reset, the waste ink drain pads need replacing. This must be performed by a qualified service person only. (See Chapter 3.)

1-24

Rev. A