Adjusting the tear-off position

If your continuous paper perforation is not aligned with the tear- off edge, you can use the micro-adjust feature to move the perforation to the tear-off position as follows:

1.Make sure both Tear Off lights are flashing (the paper is at the current tear-off position). You may need to press the Tear Off button. (See “Using the Tear Off button” on page 2-15for more information.)

2.Hold down the Pause button for about three seconds. The Pause light begins flashing and the printer enters the micro- adjust mode.

3.Press the LF/FF [D] button to feed paper forward, or press the Load/Eject [U] button to feed paper backward, until the paper perforation is aligned with the tear-off edge.

Note:

The printer has a minimum and a maximum tear-off position. If you try to adjust the tear-off position beyond these limits, the printer beeps and stops moving the paper.

Paper Handling 2-31