Printing a Self Test

Running the printer’s self test helps you determine whether the printer or the computer is causing the problem:

If the self test results are satisfactory, the printer is working properly and the problem probably results from your printer driver settings, application settings, computer, or interface cable. (Be sure to use a shielded interface cable.)

If the self test does not print properly, there is a problem with the printer. See “Problems and Solutions” on page 4-2 for possible causes and solutions to the problem.

You can print the self test using either single sheets or continuous paper of at least the following width:

Paper type

FX-880+

FX-1180+

 

 

 

Continuous paper

241 mm

376 mm

(including perforated

(9.5 inches)

(14.8 inches)

border)

 

 

 

 

 

Single sheet

A4 or letter size

A3 landscape

 

 

 

Follow these steps to perform a self test:

1.Make sure paper is loaded and the printer is turned off.

2.To run the test using the Draft font, turn on the printer while holding down the LF/FF button. To run the test using the printer’s near letter-quality fonts, hold down the Load/Eject button while you turn on the printer. Either self test can help you determine the source of your printing problem; however, the draft self test prints faster than the near letter-quality test.

After a few seconds, the printer loads the paper automatically and begins printing the self test. A series of characters is printed.

Note:

To temporarily stop the self test, press the Pause button. To resume the test, press the Pause button again.

Troubleshooting 4-17