2.Make sure the printer is turned off, and the printer cover is removed. Also make sure the tractor is installed in the pull position and the paper guide is lying flat on the printer.
3. Set the paper release lever to the pull tractor position.
4.Release the sprockets by pulling the sprocket lock levers forward.
5.Slide the left sprocket approximately 12 mm (0.5 inch) from the far left position and push the lever back to lock it in place. Then slide the right sprocket to match the width of your paper, but do not lock it. Move the center support midway between the two sprockets.
6.Make sure your paper has a clean, straight edge. Then open the sprocket covers.
Paper Handling |