Setting

Options

 

 

International character set for

Italic U.S.A., Italic France, Italic Germany,

italic table (options vary

Italic U.K., Italic Denmark 1, Italic Sweden,

depending on the country)

Italic Italy, Italic Spain 1

 

 

Manual feed wait time

1 second, 1.5 seconds, 2 seconds, 3 seconds

 

 

Buzzer

Off, On

 

 

Auto CR (carriage return)***

Off, On

 

 

IBM character table***

Table 2, Table 1

 

 

Bottom margin*

4.2 mm, 20 mm, 22 mm, 24 mm, Others

 

 

Line spacing (lines per inch)*

6 LPI, 8 LPI

 

 

Paper out override*

Off, On

 

 

*Available only in Okidata mode. (See page 3-11 for more information.)

**Not available in Okidata mode.

***Available only in IBM PPDS emulation mode.

Page length for front tractor

This setting allows you to set the page length (in inches) for the continuous paper loaded on the front push tractor.

Page length for rear tractor

This setting allows you to set the page length (in inches) for the continuous paper loaded on the rear push tractor.

Skip over perforation

This feature is available only when continuous paper is selected. When you turn on this feature, the printer provides a one-inch (25.4 mm) margin between the last line printed on one page and the first line printed on the next page. Because most application program margin settings override margin settings from the control panel, you should use this setting only if you cannot set your top and bottom margins using your application.

Using the Control Panel

3-5