2.Turn the card over so that the circuit board side is facing down, and insert it in the optional interface slot. Push gently until the card is firmly seated in the expansion slot inside the optional interface slot.
3.Tighten the retaining screws and reconnect the scanner’s cables.
circuit board, face down
The IEEE 1394 scanner interface card has two cable connectors. You can use either one to connect the scanner directly to your computer. At the same time, you can use the second connector to connect other IEEE 1394 devices in a daisy chain or tree configuration. You can also connect the scanner to another IEEE 1394 device so that it’s the last IEEE 1394 device in a chain connected to your computer.
Neither your scanner nor your computer has to be off when you connect the cable. However, be careful not to connect or disconnect the cable when the scanner is in use.
Follow these steps to connect the scanner:
1. Connect one end of the cable to the IEEE 1394 port on the card.
2. Connect the other end of the cable to the IEEE 1394 port on your computer or on another IEEE 1394 device.
22 Setting Up Your Scanner