Chapter 1:

Setting Up

the Printer

On a Network

Note: If you are using the USB interface, follow the steps on your Start Here sheet to configure the printer and install the software.

19

This chapter includes the following information:

•Connecting to the network

•Installing the software

•Updating your printer firmware

Connecting to the Network

Make sure you have the correct cable for connecting the printer. To connect to a network switch or hub, you need a standard RJ-45 “straight-through” network cable. To connect directly to your computer’s network interface, you need an RJ-45 crossover cable.

1.Turn off the printer.

2.Connect one end of the appropriate cable to the printer’s Ethernet port. Then connect the other end to your network switch or hub or your computer’s Ethernet port.

3. Turn on the printer.

Once the printer is connected to your network, you need to configure it. See “Configuring the Network Interface” on page 20 for instructions.