Epson TM-U375 user manual Adjusting the Paper Roll End Sensing Position

%h, Note:

To attach the DIP switch cover, insert the cover upward then slide the cover leftward, as shown in the illustration below.

Adjusting the Paper Roll End Sensing Position

The paper near end detector detects when the paper is almost gone by measuring the diameter of the paper roll. Software programs can use the ESC c 4 command to stop printing when the paper is almost gone.

If you want to change the amount of paper remaining when the printer stops printing, follow the steps below to adjust the paper near end detector.

,Note:

%If the inner diameter of the paper roll core is less than 10 mm (0.39 inch), the paper roll near-end detector may not work properly.

1.Open the printer cover and remove the take-up spool.

2.Determine the point on the paper roll at which you want the near-end detector to be triggered. Then measure the distance A shown in the illustration.

Setting Up the Printer 1-23