Epson TM-U375 user manual Example print control for cut sheet

Example print control for cut sheet

1) Enables printing stop due to slip paper-end.

2) Enables ASB for all status changes.

3) Receives ASB due to 2).

4) Selects slip printing.

5) Waits for slip paper to be selected.

ASB: waits for slip paper selection (ASB

4-0*) to be “selected” (0). *Indicates bit 0 of the fourth byte of the ASB data. The same rule applies correspondingly to the following:

6) Waits for slip paper to be inserted.

ASB: wait for cut sheet sensor (ASB 3-5) to be “paper p” (0).

7) To cancel the slip paper waiting state, send DLE ENQ 3.

When canceled, the printer returns to paper roll mode, and the 4 bytes of ASB are transmitted.

ASB: slip paper state (ASB 4-l) becomes “not selected” (1).

8) Waits for the slip to be loaded.

ASB: waits for the slip paper state (ASB 4-l) to be “printable” (0).

9) Transmits each line of print data until there is no data to be transmitted.

In this case, ASB is transmitted when the paper has run out.

ASB: slip paper state (ASB 4-l) becomes “not printable” (1).

Advances to step 10) when all the data has been sent.

10) Ejects the slip paper.

4-10 Reference Information