Escient MP-100 manual Installing Batteries Into Remote

FIREBALL-MP INSTALLATION & USER’S GUIDE - M22002-01A1

Installing Batteries Into Remote

1.On the back of the Remote, push the tab and remove the battery cover.

2.Obtain two (2) fully-charged AA alkaline batteries. Match the + and – marks on the batteries to the + and – marks in the battery case, then insert the new batteries.

3.Press the battery cover back into place. The tab should click when the cover is locked.

4.Test the unit by pressing any key on the remote. If the batteries are inserted correctly, the LED will blink each time you press a key.

Programming the Remote

The Remote can control up to 8 different components. Note that 3 of these are already reserved for Escient's FireBall-MP, TuneBase 200, and PowerPlay products. Perform the following instructions for each component you want controlled:

1.Turn on a component (e.g., VCR) and, if applicable, insert media, (e.g., cassette or disc). NOTE: Please read steps 2-4 completely before proceeding. We recommend highlighting or writing down the codes and device you wish to program before moving onto step 2.

2.On the Remote, press a component key once (i.e., AUX, CBL, DVD, TV, RCV). Press and hold CODE SET until the LED blinks twice, then release.

3.Use the Manufacturer’s Codes (last section in this appendix) to locate the type of component and brand name and then enter the first four-digit code for your component. If performed correctly, the LED will blink twice.

2

When batteries need replacement, the Remote will blink twice with every key press. Simply replace them and the remote control will be restored to its full functionality, including favorite settings.

APPENDIX H - REMOTE CONTROL

PAGE 140