Physically Linking Artist Series Devices | Euphonix EuCon guide

USER GUIDE

14

SETUP AND INSTALLATION

professional control surface

Two larger, detached riser brackets elevate and angle the unit more than the foldout legs. Use moderate force to snap them into the bottom panel as shown in Figure 2-1.

To remove the riser brackets:

1.Slide the side panels off (Figure 2-2left).

Figure 2-2Removing side panels (left); removing riser brackets

2.Press the tabs to release the riser brackets (Figure 2-2right).

3.Lift the riser bracket out of the MC Mix to remove

2.1.2Physically Linking Artist Series Devices

MC Mixes can be physically attached to each other to form a larger, stable control surface. An MC Control can also be joined to the MC mixes. See Surfaces on page 41 to use EuControl to link the surfaces in the desired order.

Artist Series

Image 14

Euphonix EuCon manual Physically Linking Artist Series Devices, 2Removing side panels left removing riser brackets

Contents

User Guide Communications and Safety Regulation Information User Guide Japan CanadaEuropean Union Australia Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page Introduction to the Artist Series EuControl Software Conventions Used in this User Guide Setting Up the MC Mix Elevating the MC Mix Physically Linking Artist Series Devices 2Removing side panels left removing riser brackets 3Removing screws from the bottom panel Installation 6Menu bar with EuControl icon 8Ethernet cable and rear panel jack Controlling a Second Workstation Connecting a Footswitch 10 Footswitch input on rear panelPage Common Tasks Fader Strip Press the Home key -2to restore tracks 1-8 to strips Inserts Fader strip, Inserts and Chan keys Press the page keys to access more parameters Figure Chapter Power Switch Shift Key Oled Dimming Fader StripsDisplay Screens Solo Fader3 on Transport Controls REW 6 SEL 30 4.3.7 Assign Fader Navigation Controls Bank and Nudge Navigating Among Multiple MC Mixes Not all applications support these keys Knobs Basic Knob Use Knob Modes Normal ModeChannel Mode Chan Key Knob Set Selector Keys 11Knob Selector keys MIX Knob Set Navigation Keys Configuration Pages CFGDual-Function Knobs User Guide Knob Sets and Multiple MC Mixes Back User Guide Surfaces EuControl Add B All SurfacesMy Surfaces Show Info WorkstationsRemove Attach/Detach All WorkstationsMy Workstations General General Preferences Solo Mode Preferences 46 5.4 Preferences EuControl MC Control Display FootswitchMC Mix display screen dim time Operation Assign Assign tab Clear All LayoutsDisplay application’s track numbers Recall Clear Appendix a Setting the IP Address Professional control surface