Euphonix EuCon - page 26

professional control surface

Artist Series

USER GUIDESURFACE CONTROLS

4.1 Power Switch

Press and release the POWER switch to turn the MC Mix on/off.

• All displays shows a Euphonix logo upon power up.

• All activity on the displays and LEDs ceases upon power down.

4.2 Shift Key

The Shift key is used in conjunction with other keys to access secondary functions

labeled in blue above the primary function. Two Shift keys are located at the MC

Mix’s bottom-left and -right.

The following simplified terminology is used describe Shift functions:

“Press and hold the Shift key then press the AUX key”

is written as

“press the GROUP key”

The Shift key can be locked on like caps lock on a computer keyboard by pressing

both Shift keys simultaneously. This is useful if you plan to access several Shift

functions consecutively. Press either Shift key to unlock.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page USER GUIDETABLE OF CONTENTS vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Series Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls USER GUIDETABLE OF CONTENTS viii Appendix A: Setting the IP Address Chapter 5: EuControl USER GUIDELIST OF FIGURES ix List of Figures Page INTRODUCTION TO THE ARTIST SERIES Chapter 1: Introduction to the Artist Series EuControl Software INTRODUCTION TO THE ARTIST SERIES Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Mix 2.1.1 Elevating the MC Mix 2.1.2 Physically Linking Artist Series Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls Display Screens Knob Set navigation Fader navigationPower switch Figure 4-1 MC Mix surface controls MC MIX Page 4.3 Fader Strips 4.3.1 Display Screens 4.3.2 Fader 4.3.3 ON 4.3.4 SOLO 4.3.5 Transport Controls 4.3.6 SEL 4.3.7 ASSIGN 4.3.8 REC 4.3.9 AUTO 4.4 Fader Navigation Controls 4.4.1 BANK and NUDGE 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 Navigating Among Multiple MC Mixes 4.5 Knobs 4.5.1 Basic Knob Use 4.5.2 Knob Modes 4.5.3 Knob Set Selector Keys Page 4.5.4 Dual-Function Knobs 4.5.5 Knob Set Navigation Keys Page 4.5.6 Knob Sets and Multiple MC Mixes 4.6 APPLICATION 4.7 WORKSTATION Page Chapter 5: EuControl 5.1 Surfaces Page 5.2 Workstations Page 5.3 General 5.3.1 General Preferences Page 5.4.1 MC Mix display screen dim time 5.4.2 Footswitch 5.4.3 MC Control Display Page Page Page USER GUIDESETTING THE IP ADDRESS Appendix A: Setting the IP Address professional control surface USER GUIDESETTING THE IP ADDRESS