Surfaces, EuControl | Euphonix instruction

professional control surface

Chapter 5: EuControl

EuControl is launched automatically upon starting your Mac and runs in the background. EuControl is responsible for finding, linking, and communicating with all MC Mixes and MC Controls on the network. EuControl’s configuration tasks are accessed by clicking the green icon on the Mac taskbar and selecting EuControl Settings.

Only one instance of EuControl can run on a workstation. However, multiple work- stations on a single network can each run EuControl. Each instance of EuControl can connect up to four MC Mixes on the network. These multiple MC Mixes act together as a single control surface. Once connected, these MC Mixes are not available to other instances of EuControl until relinquished.

Figure 5-1Selecting EuControl Settings from the taskbar

The tabs are discussed in the order (left to right) they appear at the top of the EuControl Settings dialog.

5.1Surfaces

The Surfaces tab shows all MC Mixes on your network and the MC Mixes connect- ed to your instance of EuControl.

USER GUIDE

41

EuControl

Artist Series

Image 41

Euphonix manual Surfaces, EuControl

Contents

User Guide User Guide Communications and Safety Regulation Information Japan CanadaEuropean Union Australia Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page EuControl Software Introduction to the Artist Series Conventions Used in this User Guide Elevating the MC Mix Setting Up the MC Mix 2Removing side panels left removing riser brackets Physically Linking Artist Series Devices 3Removing screws from the bottom panel 6Menu bar with EuControl icon Installation 8Ethernet cable and rear panel jack Controlling a Second Workstation 10 Footswitch input on rear panel Connecting a FootswitchPage Fader Strip Common Tasks Press the Home key -2to restore tracks 1-8 to strips Fader strip, Inserts and Chan keys Inserts Press the page keys to access more parameters Figure Chapter Shift Key Power Switch Oled Dimming Fader StripsDisplay Screens Solo Fader3 on REW Transport Controls 30 4.3.7 Assign 6 SEL Bank and Nudge Fader Navigation Controls Not all applications support these keys Navigating Among Multiple MC Mixes Basic Knob Use Knobs Channel Mode Normal ModeKnob Modes Chan Key 11Knob Selector keys Knob Set Selector Keys MIX Knob Set Navigation Keys Configuration Pages CFGDual-Function Knobs User Guide Back Knob Sets and Multiple MC Mixes User Guide EuControl Surfaces Add B All SurfacesMy Surfaces Show Info WorkstationsRemove Attach/Detach All WorkstationsMy Workstations General Preferences General 46 5.4 Preferences EuControl Solo Mode Preferences MC Mix display screen dim time FootswitchMC Control Display Operation Assign tab Assign Display application’s track numbers LayoutsClear All Recall Clear Appendix a Setting the IP Address Professional control surface