Euphonix EuCon - page 42

professional control surface

Artist Series

USER GUIDEEuControl

Figure 5-2 Surfaces tab

All Surfaces

All Surfaces shows all MC Mixes on the network. An MC Mix shown in light gray

is already connected either to your own or another instance of EuControl run-

ning on a different workstation. In both cases, it is not selectable.

My Surfaces

My Surfaces shows the MC Mixes connected to your instance of EuControl. If there

is more than one MC Mix in this list, they are linked into a single large surface.

The top-to-bottom order corresponds to the left-to-right order of the surfaces,

respectively. The leftmost MC Mix has fader strip 1. Use the and buttons

to reorder the list.

Each MC Mix can be renamed by double-clicking the existing name and typing a

new name.

Add B

Click Add B to add the selected All Surfaces entry to My Surfaces. This connects

this MC Mix to your instance of EuControl. You can also click and drag an MC Mix

from All Surfaces to My Surfaces.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page USER GUIDETABLE OF CONTENTS vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Series Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls USER GUIDETABLE OF CONTENTS viii Appendix A: Setting the IP Address Chapter 5: EuControl USER GUIDELIST OF FIGURES ix List of Figures Page INTRODUCTION TO THE ARTIST SERIES Chapter 1: Introduction to the Artist Series EuControl Software INTRODUCTION TO THE ARTIST SERIES Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Mix 2.1.1 Elevating the MC Mix 2.1.2 Physically Linking Artist Series Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls Display Screens Knob Set navigation Fader navigationPower switch Figure 4-1 MC Mix surface controls MC MIX Page 4.3 Fader Strips 4.3.1 Display Screens 4.3.2 Fader 4.3.3 ON 4.3.4 SOLO 4.3.5 Transport Controls 4.3.6 SEL 4.3.7 ASSIGN 4.3.8 REC 4.3.9 AUTO 4.4 Fader Navigation Controls 4.4.1 BANK and NUDGE 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 Navigating Among Multiple MC Mixes 4.5 Knobs 4.5.1 Basic Knob Use 4.5.2 Knob Modes 4.5.3 Knob Set Selector Keys Page 4.5.4 Dual-Function Knobs 4.5.5 Knob Set Navigation Keys Page 4.5.6 Knob Sets and Multiple MC Mixes 4.6 APPLICATION 4.7 WORKSTATION Page Chapter 5: EuControl 5.1 Surfaces Page 5.2 Workstations Page 5.3 General 5.3.1 General Preferences Page 5.4.1 MC Mix display screen dim time 5.4.2 Footswitch 5.4.3 MC Control Display Page Page Page USER GUIDESETTING THE IP ADDRESS Appendix A: Setting the IP Address professional control surface USER GUIDESETTING THE IP ADDRESS