Euphonix EuCon 5.3 General

professional control surface

Artist Series

USER GUIDEEuControl

5.3 General

This tab controls how the MC Mix and application software work together.

Figure 5-4 General tab

5.3.1 General Preferences

Workstation tracks knob set changes

The workstation is aware of which knobset is selected and displays appropriate

controls.

Open plug-ins on workstation when editing

When a plug-in knobset is selected on the MC Mix, the workstation opens the

plug-in’s window.

Close plug-ins on workstation when editing

When a plug-in’s knobset is navigated from on the MC Mix, the workstation closes

the plug-in’s window.

Select by Touch

Touching an MC Mix fader selects that track in the application and attentions it

on the MC Mix. This is the same as pressing the fader SEL key.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page USER GUIDETABLE OF CONTENTS vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Series Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls USER GUIDETABLE OF CONTENTS viii Appendix A: Setting the IP Address Chapter 5: EuControl USER GUIDELIST OF FIGURES ix List of Figures Page INTRODUCTION TO THE ARTIST SERIES Chapter 1: Introduction to the Artist Series EuControl Software INTRODUCTION TO THE ARTIST SERIES Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Mix 2.1.1 Elevating the MC Mix 2.1.2 Physically Linking Artist Series Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls Display Screens Knob Set navigation Fader navigationPower switch Figure 4-1 MC Mix surface controls MC MIX Page 4.3 Fader Strips 4.3.1 Display Screens 4.3.2 Fader 4.3.3 ON 4.3.4 SOLO 4.3.5 Transport Controls 4.3.6 SEL 4.3.7 ASSIGN 4.3.8 REC 4.3.9 AUTO 4.4 Fader Navigation Controls 4.4.1 BANK and NUDGE 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 Navigating Among Multiple MC Mixes 4.5 Knobs 4.5.1 Basic Knob Use 4.5.2 Knob Modes 4.5.3 Knob Set Selector Keys Page 4.5.4 Dual-Function Knobs 4.5.5 Knob Set Navigation Keys Page 4.5.6 Knob Sets and Multiple MC Mixes 4.6 APPLICATION 4.7 WORKSTATION Page Chapter 5: EuControl 5.1 Surfaces Page 5.2 Workstations Page 5.3 General 5.3.1 General Preferences Page 5.4.1 MC Mix display screen dim time 5.4.2 Footswitch 5.4.3 MC Control Display Page Page Page USER GUIDESETTING THE IP ADDRESS Appendix A: Setting the IP Address professional control surface USER GUIDESETTING THE IP ADDRESS