Excalibur electronic P95-LP3 Facing Requirement, Hearth Requirements, Facing Over 1 25mm Thick

INSTALLATION

4) Note: The unit does not
have to be completely
enclosed in a chase. The
clearance on top of the
unit is 0" to the standoffs
so combustible building
materials can be laid
directly on top of the
standoffs. You	must
maintain clearance from
the vent to combustible
materials for	both
rigid and flex, see the
"Clearances" section.

Combustible	Material
-combustible	Material
Non

2"

2-1/4”

Header
	11” dia. hole
	through wall
	for Flex
	or for DuraVent
		C
		L
	48-3/4”	53-3/4”
	2-7/8”
4"	21-1/8” (533mm)

Facing Over 1" (25mm) Thick

If the facing material is over 1" (25mm) thick (example: brick or river rock), install the facing around the perimeter of the face. You may wish to make a face template as shown on the diagram.

FPI offers a cover plate template. See the "Optional Cover Plate Template" section.

Gas connection

on this side

Note: 53-3/4" is the minimum height for both flex termination or Simpson Dura-Vent venting.

The HeatWave Duct Kit has different clearance and framing requirements, check the HeatWave manual for details.

NOTE: If using a brick hearth, the fi replace will need to be raised to accommodate the brick thickness. Example: If the brick is 2" thick, the unit must be raised 1".

FACING REQUIREMENT

This fi replace requires a non-combustible material extending from the framing header and sides.

The fl anges on the front face of the fi replace are for a facing thickness of 1" (25mm).

Please note thatall vertical measurements are taken from the base of the unit excludingrisersorbottom stand-offs.

HEARTH REQUIREMENTS

Floor Mounted Fireplaces

Raised Fireplaces

No hearth is required when the unit is raised 3" (76mm) off of the floor surface

	You	must	take
	into	account the
	depth of the fl oor
	covering (carpet,
	tile,	linoleum,	etc.)
Fireplace	when determining
	the	height of the
Stand

fi replace stand.

Excalibur® P95-3 Zero Clearance Direct Vent Gas Fireplace 9