INSTALLATION
GLASS DOOR
INSTALLATION
1)Fit top door bracket over the fl ange at the top of the fi rebox.
2)Secure with 3 screws on the bottom.
3)Mount the 2 screws back onto the mounting plate on the rear of the facade through the tab on the glass frame and then tighten screw to secure.
OPTIONAL
SCREEN DOORS
1)Attach door bracket to side using 2 screws to the left and right side of the unit.
Flange
Door
Door Bracket attaches with 2 screws.
Tighten both screws to secure Front
Facade to Glass Door.
2) Slide the door(s) onto the hinges.
Tab
Screw
FRONT FACADE
1)Remove the 2 screws from the mounting plate that are on the back of the facade.
Remove screws from the mount-
ing tabs.
2)Place the Front Facade into position by sliding the 2 holes in the bottom brackets over the pins on the base, one on each side.
View from underneath of the
screw and the bracket.
4)Slide Bottom Louver into position. On each side secure the bottom screw fi rst into the side bracket. Do not overtighten, leave slightly loose to allow the louver to move freely.
Secure
Screw
5)Attach the two control boxes to the bottom unit base and tighten the 2 screws on the left side and 1 screw on the right side.
Adjusting the Plunger: Loosen the screw that holds that plunger bracket so that you can remove the plunger.
Loosen the
screw holding
the bracket.
Once the plunger has been removed take a pin and put it in the hole that is in the round part of the plunger and adjust it accordingly by turning it to the left or right.
Bracket Pin
Fit the bottom brackets over
the pins on the base.
Secure left side with 2 screws and right
side with one screw.
Adjust plunger by turning it to the left or right with a pin.
Excalibur® | 29 |
