Chapter 5 • Upgrades and Troubleshooting
5.Connect the
6.Connect the AC Power cable(s) to the BME(s). (Page
7.Apply AC power to the BMEs and Verify Normal
8.Do the steps under “After Hardware Changes” on Page
9.Connect cables to BMEs (video, sync and/or audio cables). (Page
The procedure for adding a Video and/or an Audio BME follows.
Adding a Video and/or an Audio BME
Matrix 3200/6400 Video BME(s) and/or a Matrix 6400 Audio BME may be installed in a rack with an existing Matrix 3200/6400 Video system, or in a different location. BMEs may be separated by up to 12 feet and rack mounting is NOT required. If the Video and/or Audio BME(s) are going to be rack mounted with other BMEs, they may be mounted in any order within a rack or cabinet. There are no restrictions to the order in which BMEs may be mounted relative to each other. Logically, the BME addresses in a system such as the one shown in Figure
Equipment location within a room should be given careful consideration. Poor planning, with the number of cables involved, could result in a cluttered appearance. Power requirements and
the amount of heat exhaust from the system should be taken into consideration.
The following restrictions apply to installing BMEs.
•One BME must be assigned as BME#0.
•A BME with an FPC 1000 must be BME#0.
•Address assignments must not skip numbers.
•Address assignments of 0 - 5 are accepted, BMEs w/address
•A Matrix 3200/6400 Video system is limited to a maximum of 3 Video and one Audio BME(s).
See Page
MATRIX 6400 |
VIDEO |
MATRIX 6400 |
VIDEO |
MATRIX 6400 |
VIDEO |
MATRIX 6400 |
AUDIO |
Figure 5-10.A Example of a Matrix 3200/6400 Video rack-mounted system
Extron • Matrix 3200/6400 Series • User’s Manual |
