Powering the Falcon
Figure 5. Installing the Battery Pack
Battery Door Latches
Battery Door
Plastic Pull Tab
Unhook/hook Strap As Needed
Battery
Strap Studs
Falcon
Cover Plate (unit may have Handle here instead)
2.Turn the battery door latches to unlock the battery door. Remove the door.
3.Insert the battery pack with the pull tab on the outside and the bat- tery contacts aligned with the matching contacts inside the battery compartment. The battery pack has a keying feature on one side to prevent incorrect installation (refer to Figure 5).
4.Replace the battery door by inserting the bottom tab into the slot. If the battery pack is installed incorrectly, the door will not seat properly.
5.Rotate the battery door latches on the battery door towards the base of the unit.
6.On the 441X, replace the handstrap hook on the strap stud at the base of the unit.
If you remove the battery pack or the battery fails, you have about 30 minutes to swap in a new battery pack or charge the battery pack before the backup battery fails (if the backup battery has been fully charged).
Quick Reference Guide | 11 |
