E. CLEANING THE INSIDE OF THE PRINTER
As you use your printer, dust and other foreign particles may accumulate inside the printer’s case. These particles are attracted to the underside of the ribbon by static produced during printing and can cause voids on the printed image.
Periodically, use the following procedure to remove dust and other foreign particles:
1.Open the printer’s Top Covers.
2.Remove the ribbon and overlaminate from the printer.
3.Use a Cleaning Pad from the Printer Cleaning Kit or a soft,
4.Once the cleaned areas are completely dry and free of foreign debris,
F.CLEARING A CARD JAM
If a card becomes jammed inside the printer, the LCD Display will indicate approximately where it is jammed. At this point you can either try to correct the problem and continue printing with the same card, or remove the card completely and continue printing with a new card. Refer to the following steps for instructions on doing either:
1.Leave the power ON, and open of the printer’s Top Covers.
2.Remove the ribbon and overlaminate as needed.
3.If you would like to try to correct the problem and continue printing with the same card, do so by pressing the On/Cancel button to advance the card or the Pause/Resume button to reverse the card. Use these buttons to help free the card from its jam. Try not to move the card too far from where it was just before the jam occurred. Once the jam is cleared, replace media, close the Top Cover(s), and press the Pause/Resume button to resume printing.
4.If you would like to remove the jammed card completely, do so by using the On/Cancel and Pause/Resume buttons to manually eject the card. Then, replace media, close the Top Covers, and press the On/Cancel button. At this point, the LCD Display will prompt you to either press the Pause/Resume button or the On/Cancel button. Pressing the Pause/Resume button will cause the printer to feed in a new card and reprint the job which originally jammed along with all subsequent jobs still being sent. Pressing the On/Cancel button will reboot the printer and cancel all jobs within the printer’s memory. In this case, you must also cancel and resend the print jobs from your computer.
52
Section 7: Maintenance
