FARGO electronic Pro-L manual B. Adjusting The Internal Card Guides

Pro-L Card Printer User’s Manual

1.Open the Card Hopper Door located on the right-hand side of the printer’s exterior by grasping the top of the door and pulling straight down. Allow the door to swing completely open.

2.As you are looking straight into the Card Hopper, locate the left Card Input Guide and loosen the two screws which fasten it to the back plate of the Card Hopper.

3.Once these two screws have been loosened, it is possible to move the left Card Input Guide slightly to the right or to the left. Insert the stack of cards.

4.Adjust the left Card Input Guide so it rests flush against the side of the card stack, and re-tighten the two screws loosened in the previous steps. Adjustment to the left Card Input Guide is now complete. If the cards being inserted are 2.3” (58mm) or wider, refer to Part B of this section.

B.ADJUSTING THE INTERNAL CARD GUIDES

Two Internal Card Guides reside inside the printer. These Internal Card Guides are also adjustable to accommodate varying card widths. Although these card guides are spring-loaded and will automatically adjust to slight card width variations, a manual adjustment must be made in order for the printer to accept cards 2.3” (58mm) or wider. Please refer to the following steps to adjust both of the Internal Card Guides:

1.Open both Top Covers of the printer by pressing the Cover Release Buttons. Allow the covers to swing up and open.

Drive Rollers

Internal	Card Guide	Card Guide Screws
Card Guides
	Mounting Screws

2.Remove the ribbon and overlaminate rolls from the printer.

58

Section 8: Mechanical Adjustments