D. ADJUSTING THE LAMINATOR
If applying PolyGuard overlaminate, you may find that the individual polyester chips from the overlaminate roll may sometimes be slightly
Screws
Card | Card Flipping |
Guide Rail | Mechanism |
1.If the PolyGuard chips are being applied too closely to, or overlapping, a card’s top or bottom edge (as the card travels through the printer), the laminator’s Card Guide Rail should be adjusted. To do this, simply loosen the two screws which fasten the Card Guide Rail to the printer’s main chassis.
2.If the PolyGuard chip is being placed more toward a card’s top edge (as shown), move the Card Guide Rail slightly toward the rear of the printer (opposite the direction you would like the chip to move).
62
Section 8: Mechanical Adjustments