BOTTOM Line of LCD (continued)
Message | Cause | Solution |
|
|
|
Lam Jam/Out | The overlaminate has | If jammed, clear it according |
| become jammed in the | to the instructions in |
| printer rollers, is stuck | Section |
| to the surface of the card | more overlaminate |
| is broken, or has run out. | (see Section |
|
| Pause/Resume button to |
|
| continue. |
|
|
|
Lam Ready | Indicates printer is ready to |
|
| laminate. |
|
|
|
|
Lam Turned Off | Indicates laminator is OFF. |
|
| The laminator can be |
|
| turned off by setting |
|
| switches 4 & 5 of the |
|
| printer’s internal switches |
|
| down (towards the circuit |
|
| board). |
|
|
|
|
Laminating | Indicates printer is |
|
| laminating. |
|
|
|
|
Lamination roller is unable | Press Pause/Resume button | |
| to lower. | to retry. If failure continues |
|
| call for technical assistance. |
|
|
|
Lamination roller is unable | Press Pause/Resume button | |
| to raise. | to retry. If failure continues |
|
| call for technical assistance. |
|
|
|
Sensor Calibrate | Indicates the Lamination |
|
| Sensor is calibrating. |
|
|
|
|
Wrong Lam Type | The wrong overlaminate is | Check that you have the |
| installed. | proper overlaminate |
|
| installed according to the |
|
| Lamination option selected |
|
| in the printer driver setup |
|
| window (see Section |
|
|
|
74
Section 9: Troubleshooting