First Alert FA1220CV technical manual D Speed Key Macros, General Information Defining, Executing

Enter your user code +

ENTER SPEED KEY "D" existing sequence displayed

Technical Manuals Online! - http://www.tech-man.com

General

Information

Defining

NOTE: Defining and using speed keys requires an alpha keypad.

Executing

[D] Speed Key (Macros)

The "D" key can activate a string of up to 16 keystrokes. These keystrokes are known as a macro and are stored in the system's memory. Typical Speed Key functions include:

•Seldom used but repeatable sequences.

•Arming sequences that involve bypassing certain zones before arming.

•Relay activation sequences.

# + D and hold the “D” key down until the following appears:

Enter up to 16 keystrokes. A speed key sequence can include different commands. Press the "D" key to separate different commands.

For example, you may want to perform the following sequence.

GOTO partition 2	Enter *2
Bypass zones 10 & 11	Press bypass [6], then the zone numbers 10 & 11
Arm in maximum mode	Press maximum [4] key
Return to partition 1	Enter *1
To program this sequence, type the following : ✱ 2		D	61011	D	4	D	✱ 1	D	D

Note that the "D" key is pressed after the "2," the last "1" and the "4," separating the different commands. Press "D" twice to complete the entry and exit.

Press and hold down (about 2 seconds) the "D" key until the following prompt appears:

ENTER USER CODE	Enter your user code. The defined speed key sequence will
	begin automatically.
0000

NOTE: When defining speed key sequences, do not use the [#] key to represent Quick Arming. The system uses the code entered at the prompt to initiate commands in a speed key sequence, so quick arm is unnecessary. The system interprets the use of the [#] key in a speed key sequence as its designated function only (usually installer functions).

– 33 –