Technical Manuals Online! -
|
| TESTING THE SYSTEM |
|
| (Continued) |
Testing Your | 1. Open and close each protected door and window in turn and listen for three beeps. The | |
System |
| identification of each faulted protection point should appear on the display. |
| 2. | Walk in front of any interior motion detectors (if used) and listen for three beeps as |
|
| movement is detected. The identification of the detector should appear on the display when |
|
| it is activated. |
|
| NOTE: Wireless motion detectors activate only once in a |
|
| battery life. |
| 3. | Follow the manufacturer's instructions to test all smoke detectors to ensure that all are |
|
| functioning properly. The identification of each detector (or the zone number of the zone |
|
| assigned to the detector) should appear on the display when each is activated. |
| 4. | When all protection points have been checked, there should be no zone identification |
|
| numbers displayed. If a problem is experienced with any protection point (no confirming |
|
| sounds, no display), CALL FOR SERVICE IMMEDIATELY. |
| 5. | Turn off Test mode by entering the security code and pressing the OFF key. |
