lower 40GbE base-module port and stack-group 1 defines the stack group for the upper 40GbE base-module port. To display the ports in each stack group, enter the show system stack-unit unit-numberstack-group command.

2Save the stacking configuration on the 40GbE ports:

FTOS# write memory

3Repeat Steps 1 and 2 on each MXL 10/40GbE Switch in the stack by entering the stack-unit 0 stack-group 0 and stack-unit 0 stack-group 1 commands and saving the configuration.

4Reboot each switch by entering the reload command in EXEC Privilege mode:

FTOS# reload

If the stacked switches all reboot at approximately the same time, the switch with the highest MAC address is automatically elected as the Master Switch. The switch with the next highest MAC address is elected as Standby Master.

To configure the stack so that the roles are assigned according to pre-determined priorities, enter the stack-unit priority command as described in the Note below.

To reload the stack, connect the terminal to the Master Switch and enter the reload command in EXEC Privilege mode. If you connect the terminal to a member (non-Master) switch, you will not be able to access the CLI.

To determine which switch is the Stack Master, enter the show system command at the terminal.

To remove a port from stacking mode, use the no form of the stack-unit stack- group command; for example, no stack-unit 0 stack-group 0. After entering the command, save the configuration and reload the switch for the change to take effect. When the reload completes, the port comes up in 40GbE mode if it is on the base module and in 4x10GbE (quad) mode if the port is on a plug-in module.

NOTE: You can also manually configure the switch that will be master by entering the stack-unitunit-numberpriority number command in CONFIGURATION mode on each stacked switch, where:

stack-unitunit-numberidentifies the switch in the stack.

priority number specifies the management priority. Range: 1-14. Default: 0.

The switch with the highest priority number is elected Master. The switch with the next highest priority number is elected Standby Master and takes over stack

Assembling a Switch Stack

27

Page 27
Image 27
Force10 Networks CC-C-BLNK-LC manual Save the stacking configuration on the 40GbE ports