See also:

For more information on the battery indicator, see “Chapter 5. The Launcher” on page 67.

See also:

For more information on connecting your device using a serial connector, see “Appendix B. Serial Port Connection” on page 207.

Your eBookMan powers on, and the tour begins. Tap the introductory sentence in the language you want to view the tour. It ends with a picture of the device with an arrow. The tour appears only after the device is left without battery power for more than five minutes or when a hard reset is performed.

Replacing Batteries

When eBookMan is on, a battery indicator appears in the Status bar of the Launcher. The battery indicator is a graphic that shows the energy left in the batteries. Replace batteries when the battery indicator runs low.

It is best not to wait for the indicator to empty. Should the battery power run too low, the unit will start up when you press On/Off but will then shut off automatically. When this happens, please replace the batteries immediately.

1.Turn the device off.

Warning: If you change your batteries when the device is on, your device will reset and you will lose your data.

2.Attach the eBookMan protective cover to the device and turn the device over.

Note: When changing batteries, make sure the device is not on a hard surface. If the On/Off button is pressed accidentally, your data will be lost.

3.Follow the steps under “Install Batteries.”

Warning: To prevent data loss, synchronize often to back up your data, and take no more than one minute to replace the batteries. It is best to replace the bat- teries as soon as the low battery warning appears. If your unit does not power on or stay on, please replace the batteries.

III. Connect eBookMan to a PC

eBookMan has a built in USB port and comes with a cable or cradle to connect it to your desktop or laptop computer. If you do not have a USB port, a USB-to-serial connector can be purchased from www.franklin.com/ebookman/accessories.asp or your local retailer.

20 Chapter 1. Getting Started