Frymaster 47 Series Burner will not, light, Solid state analog, controller power and, mode

6.2Troubleshooting Fryers with Solid State (Analog), Digital, or CM III Controllers or Basket Lift Timers

PROBLEM	PROBABLE CAUSES		CORRECTIVE ACTION
	A. Pilot not lit (units w/pilot ignition	A. Light pilot per instructions in
	only).		Chapter 3 of this manual.
	B. Drain valve open.	B. Verify that drain valve is fully
			closed.
	C. No electrical power to unit.	C. Verify that unit is plugged in and
			that circuit breaker is not tripped.
		D. Verify that the gas line quick
			disconnect is properly connected,
Burner will not	D. No gas being supplied to unit.		that any cutoff valves between the
			fryer and the gas main are open,
light.			and that the main gas cutoff valve
			is open.
	E. Blown fuse on ignition module or	E. Replace fuse per instructions in
	interface board (units w/electronic		Section 6.6 of this manual.
	ignition only).
		F.	If available, substitute controller
			known to be good for suspect
	F. Failed controller.		controller. If fryer operates
			normally, order replacement
			controller from FASC.
Solid state (analog)
controller power and		If available, substitute controller
trouble lights on, but
heat light is not,		known to be good for suspect
	Failed controller.	controller. If fryer operates
OR		normally, order replacement
LED display shows		controller from FASC.
.
		If available, substitute controller
Unit stays in melt		known to be good for suspect
	Failed controller.	controller. If fryer operates
cycle continuously.
		normally, order replacement
		controller from FASC.
		A. Disconnect unit from electrical
	A. Temporary controller malfunction		power, wait at least one minute,
CM III will not go	caused by voltage surge.		reconnect unit to the power
			supply and turn controller on.
into programming		B.	If available, substitute controller
mode.			known to be good for suspect
	B. Failed controller.		controller. If fryer operates
			normally, order replacement
			controller from FASC.

6-2