Frymaster 47 Series Pump starts, but no, Transfer takes place, Or the transfer is, Very slow

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
	C. Pump blockage.	C. Pump blockages are usually
	Test: Close the drain valve. Place	caused by sediment build-up in
		the pump due to improperly sized
	the filter handle in the OFF	or installed filter paper and failure
	position, allow the pump to cool	to use the crumb screen. Call
	for at least 45 minutes, and then	FASC to have blockage cleared.
	press the reset button on the pump	Ensure that filter paper is of the
	motor. Pull the filter pan from the
	unit and then activate the pump.	proper size and is installed
	If the pump motor hums and then	properly, and that the crumb
	stops, the pump is blocked.	screen is used.
		A. To properly filter, the oil or
		shortening should be at or near
		350°F (177°C). At temperatures
		lower than this, the oil/shortening
		becomes too thick to pass through
	A. Cooking oil/shortening is too cold	the filter medium easily, resulting
	for filtering.	in much slower oil return and
		eventual overheating of the filter
		pump motor. Ensure that the
		cooking oil/shortening is at or
		near frying temperature before
		draining into filter pan.
Pump starts, but no	B. Improperly installed or prepared
	filter pan components.
transfer takes place		B. Remove the oil from the filter pan
or the transfer is	Test: Close the drain valve.	and replace the filter paper,
very slow.	Move the filter handle to the OFF	ensuring that the filter screen is in
	position, pull the filter pan (and	place under the paper.
	Power Shower, if so equipped)
	from the unit. Move the filter	If this does not correct the
	handle to the ON position.	problem, the filter tube suction
		tube is probably blocked. Remove
	If a strong stream of air is being	the blockage using a thin, flexible
	pumped out of the oil return port	wire. If unable to remove the
	(or the Power Shower port), the	blockage, call FASC.
	problem is with the filter pan
	components.
	C. Missing or worn filter connection	C. Verify that filter connection
	O-rings.	O-rings are present and in good
		condition.

6-5