Frymaster 47 Series operation manual Power Shower is not, Spraying properly

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
	A. Plugged openings or solidified
	shortening in the Power Shower.	A. Clean the Power Shower per
	Test: Look for oil/shortening
		instructions in Chapter 5 of this
	squirting out around the Power	manual.
	Shower gasket. If so, Power
Power Shower is not	Shower is obstructed.
	B. Missing/worn O-rings and gasket	B. Verify that O-rings and gasket are
spraying properly.
	on Power Shower.	present and in good condition.
	C. Missing paper in filter pan. (This
	causes too much pressure in the
	oil return lines, resulting in a	C. Verify that filter paper is properly
	strong flow through the Power	installed in the filter pan.
	Shower, but also squirting of oil
	from around the gasket.)

6.6Replacing the Ignition Module Fuse in Units with Electronic Ignition

1.Disconnect the fryer from the electrical supply and remove the two screws in the upper corners of the control panel. Swing the panel open from the top, allowing it to rest on its hinge tabs.

2.Locate the 3-amp ignition module fuse (refer to illustration below) and, using a fuse-puller, remove and replace it with a new fuse.

Ignition Module

Depending upon when the unit was manufactured, full vat units may have either one or two ignition modules. If there is only one ignition module, the fuse will be mounted on the interface board.

Dual vat units and some full vat units will have two ignigiton modules. Look for the fuse on the left side of the module. If there are no fuses on the modules, the fuse will be on the interface board.

For units in which the ignition module has no fuse, replace the

upper fuse on the interface board.

3.Close the panel, replace the control panel screws, and reconnect the fryer to the electrical supply.

6-6