Fujitsu 3XAX-00803AAS user manual Procedure 2-1 Modem Hardware Installation

In Commercial Confidence Installation and Software Setup for PCs Running Windows

Modem Hardware Installation

Follow procedure Procedure 2-1and Figure 2-1to install your modem, set up the cables, computer, telephone and Splitter.

Note: Do not connect the ADSL USB modem to the computer.

Figure 2-1: Connecting the Modem

Install the ADSL USB Modem by following Procedure 2-1with the PC running:

Procedure 2-1: Modem Hardware Installation

1.Locate the master telephone wall outlet and unplug any telephone cable that is connected to the outlet.

2.Plug the Splitter into the wall outlet.

3.Plug in the cable from the Splitter to Modem (the ADSL jack).

4.Put the square end of the USB cable near the USB port of the ADSL USB Modem to check that it will reach. Do not plug it in yet, further instructions will tell you when to plug it in.

5.Insert the rectangular end of a USB cable into the USB port of your computer.

6.Connect the telephone wiring to the Splitter.

ADSL USB Modem - User Manual	Page 2 - 5
FTEL	Issue 02 March 02