Fujitsu fi-5950 ■Settings, ［Device setting］, Item, Default, Explanation, Selectable parameter, 1828.1 Scanner Settings

■Settings

Using the Software Operation Panel, you can configure the following settings for the scanner connected to the PC.

ATTENTION

In View Only mode, the Software Operation Panel cannot be set. For details on "View Only mode", refer to "Password Setting" on page 175

［Device setting］

Item	Explanation	Selectable parameter	Default
Page Counter	For evaluating the consumable replace-	After Cleaning/Pad/Pick roller/Sepa-	-
(Consumables	ment cycle or cleaning cycle.	rator Roller/Brake roller/Remaining
counter)	Use this function to reset the counters	ink level (only for the imprinter
	after replacing consumables or the	option)
	cleaning.
	Refer to “5.1 Consumables and
	Replacement Cycle” on page 120.
Power saving	Select the waiting time before entering	Setting range 15 to 55 minutes (set in	15 min.
	the Power saving mode.	steps of 5 min.)
	Refer to “8.2 Power saving setting”
	on page 187.
Offset setting	Adjust the start position for the docu-	Left right: setting range -2 to 3mm	left right
	ment scanning.	(set in 0.5mm steps)	0mm
	Refer to “8.3 Offset/Scan scale” on	Up down: setting range -2 to 3mm (set	up down
	page 188.	in steps of 0.5mm)	0mm
Vertical magnifi-	Adjust the magnification in the feed-	Setting range -6.3% to 6.3% (set in	0%
cation Adjustment	ing direction.	0.1% steps)
	Refer to “8.3 Offset/Scan scale” on
	page 188.

1828.1 Scanner Settings