Fujitsu fi-5950 1.2 Operator panel, 1.2 Operator panel

1.2 Operator panel

The operator panel is located on the right side of the scanner. The panel consists of a Function Number Display, buttons and LEDs.

Function number display

	Function
	Hopper Height
Hopper Height
P
owerThickness
Sendto	Paper Thickness
Scan
Thin	Thick

Sendto Scan

Name	Function
Function Number dis-	Shows the status of the scanner.
play and Function button	For details, refer to "Indications on the Function Number Display" (page 6).

Function

Hopper height				Use these buttons to adjust the height of the Hopper to the Upper/Middle/
adjustment button				Lower Positions.
	Hopper Height			The hopper moves automatically to the right position after recieving a scan-
				ning command. However, this may cause a delay before the actual scanning
				starts. To avoid unnecessary waiting time, it is recommended to set the hop-
				per height prior to scanning. For details, refer to “2.5 Setting the Hopper
				Height” on page 15.
Document thickness				Use this buttons, to set the paper thickness of the documents.
adjustment button				(Normally no need to change from the default setting)
	Paper Thickness			For details, refer to “2.9 Setting the Paper Thickness” on page 29.
Thin			Thick
[Send to] button				Use this button to start linked application.
		Sendto		When this button is pressed at manual feed mode, the scanning stops immedi-
				ately.
				(* About the settings, refer to section “2.14 Before Using [Scan] / [Send to]
				button” on page 60, or the TWAIN Driver help.)
[Scan] button				Use this button to start linked application.
		Scan		When this button is pressed during scanning operation, the scanning is can-
				celled.
				(* About the settings, refer to section “2.14 Before Using [Scan] / [Send to]
				button” on page 60, or the TWAIN Driver help.)
Power button				Use this button to turn the power ON/OFF.
				When the power is turned on, the button is illuminated in blue.

1

PARTS OF FUNCTIONS AND NAMES

1.2 Operator panel 5