Fujitsu fi-5950 8.8 Pre-Pick, Refer to, 8.8 Pre-Pick, 3.Select “Yes” or “No” for Pre-Pick, Start up the Software Operation Panel, 1.Start up the Software Operation Panel

8.8 Pre-Pick

To scan documents consecutively, you can previously pick the document to be scanned next. This operation is called Pre-Pick.

By enabling Pre-Pick, the time interval between the scanning of two separate documents can be shortened.

Configure the settings for the Pre-Pick as follows:

1.Start up the Software Operation Panel.

Refer to “8.1 Scanner Settings” on page 173.

2.Select [Device Setting 2] from left side list in the window, and select [Pre- Pick] from its lower level.

8

SETTINGS SCANNER

3.Select “Yes” or “No” for Pre-Pick.Select “Yes” to make Pre-pick valid, and select “No” to make it invalid.

HINT

By enabling Pre-Pick, faster scanning can be achieved.

While Pre-Pick is valid, if you cancel scanning in process, you have to reload the document after ejecting all the pre-picked document.

•This setting is also available by device driver setting. In this case device driver setting has a priority to the setting by this section.

8.8 Pre-Pick 199