Fujitsu fi-5950 2.11 Starting Scanning with Button, Refer to the section, press the [Send to] button, Load the documents on the hopper, 1.Load the documents on the hopper

2.11 Starting Scanning with Button

Pressing the [Scan] / [Send to] button can start an application previously linked.

However, you need to set the application for [Scan] and [Send to] button referring to “2.14 Before Using [Scan] / [Send to] button” on page 60.

1.Load the documents on the hopper.

Refer to the section “2.6 Loading Documents on the Hopper” on page 17.

2.Adjust the stacker table to the document size.

Refer to “2.7 Setting up the Stacker” on page 22.3.Press the [Scan] or [Send to] button.When using the [Scan] button, press the button.

When using the [Send to] button, you can set from [Send to 1 to 9] of nine (9) kinds of settings.

Each pressing the [Function] button increases the number of Function Number display as 1 2 3.... Set the number that links the application software you want to use for scanning and

press the [Send to] button.

Function Number display	[Function] button
	Function
	Hopper Height
Function
Hopper Height
PowerThickness
Sendto
Scan
	Paper Thickness
Thin			Thick
	Sendto	Scan

2

OPERATIONS SCANNER BASIC

⇒The application previously set for the number is started.

ATTENTION

If the [Send to] button is pressed when "C" is displayed in the Function Number Display, the Software Operation Panel will start (see page 173).

2.11 Starting Scanning with Button 35