Fujitsu fi-5950 ■Continuous Feed, Set the scanning condition, 1.Open the hopper if it is closed, “2.10 Scanning Documents” on page, 402.12 Feeding Documents Manually

■Continuous Feed

1.Open the hopper if it is closed.Refer to section “2.2 Opening and Closing the Hopper” on page 10.

2. Press down the Hopper Height Button ( ) on the Operator Panel for more than 3 seconds.

Function
Hopper Height
Function
Hopper Height
PowerThickness
Sendto
Scan
Paper Thickness
Thin	Thick
Sendto	Scan

⇒Hopper will move up to the manual feed position.

ATTENTION

•Be careful not to get your fingers or anything caught in the mechanism when the hopper table moves up.

•To deactivate the “Manual Feed Mode” (Continuous Feed) in the middle

of an operation, press down the Hopper Height Button ( ) on the Operator Panel for more than 3 seconds.

3.Place documents face-up at the center of the hopper table.

At this moment, do not stick the top edge of the document against the inner side of the hopper, instead set them a bit apart.

4.Start the application and display the scanner driver screen.

Set the scanning condition.

For the information about how to run the scanner driver, refer to “2.10 Scanning Documents” on page 30.

402.12 Feeding Documents Manually