Fujitsu fi-5950 IMP, RED, Code, Sensor Name, played between and, 3.According to section, 14EXT sensor (one piece in the upper transport path)

*2 Turn off the scanner. Reinstall the ink cartridge according to the Operator’s Guide of Imprinter, and then turn on the scanner again.

*3 Turn off the scanner. Reinstall the option board properly, and then turn on the scanner again.

*4 1.If any abnormality occurs, turn off the scanner once, and then turn it on again.

2.If doing this (step 1) does not improve the situation, press the and buttons, which are labeled as “Paper thickness” on the operator panel, for at least 2 seconds. Write down two characters dis-

played between and .Example: In this case, “14” is displayed on the panel.

3.According to section “4.5 Cleaning the Transport path and the sensors” on page 114 , clean respective sensors for each code as shown in the table below.

Code	Sensor Name
1b	Supersonic sensor (three pieces in the upper and lower transport paths; respectively)

11Pick sensor (one piece in the lower transport path)Reflector for pick sensor (one piece in the upper transport path)17Skew sensor (six pieces in the lower transport path)Reflector for skew sensor (six pieces in the upper transport path)

12IMP top-sensor (one piece in the upper and lower transport paths; respectively)

13RED top-sensor (one piece in the upper and lower transport paths; respectively)

15REJ sensor (one piece in the upper and lower transport paths; respectively)14EXT sensor (one piece in the upper transport path)

6

PROBLEMS COMMON SOLVING

6.2 Error messages of the Operator panel 139