Length

ATTENTION

:When checking the document length, select the length difference for which a Multi- feed will be detected. Select 10/15/20mm. If the detected document length is smaller than the selected size, it will be recognized as a Multifeed.

•When scanning documents of different length together in the same stack, select [Checking Overlapping].

•If something is glued to the documents (stamps, memo or photos), they will be recognized as Multifeed when using [Checking Overlapping]. When scanning such documents, use [Checking Length] instead.

However, when using the [detection area/none-detection area] function, you can also use [Checking Overlapping].

•The setting above can be done as well on the scanner driver configuration window.

(In this case, the scanner driver selection will have priority)

8

SCANNER

Following setting is available only when [Check Overlapping] is specified above.

4.Select [Device Setting 2] from left side list in the window, and select [Document check area specification for Multifeed Detection] from its lower level.

SETTINGS

8.4 Multifeed Detection 191