Appendix

(6)Power on

1)Set Power button on the front panel to [ON].

2)Make sure that that PWR LED lamp on the front panel is on.

(7)Unit test

1)Since this device executes a self-check immediately after power is turned on, make sure that the RDY LED on the front of the panel does not light after power is turned on.

2)The LEDs light if the self-check detects an unusual condition.

(8)System test

1)Set-up check

Various devices settings complying with the system specification are made from the control terminal either directly or via the network.

2) Input video check

Make sure that the video input to the device is correctly output to the monitor (television).

3) Data communication check

Make sure that the line used by the system is connected.

4)Status check

After the final setup, when the equipment is in the system operation state, make sure that the device status LED (RDY) on the front of the device lights in green, and that the alarm LED (ALM) is off.

IP-9610

65