Fujitsu MPC3065AH, MPC3045AH manual Information to be read by Identify Device command 2

Table 5.5 Information to be read by IDENTIFY DEVICE command (2 of 3)

*1	Word 0: General configuration
	Bit 15: 0 = ATA device				0
	Bit 14-8: Vendor specific				0
	Bit 7: 1 = Removable media device				0
	Bit 6: 1 = not removable controller and/or device				1
	Bit 5-1: Vendor specific				0
	Bit 0: Reserved				0
*2	Word 10-19: Serial number; ASCII code (20 characters, right-justified)
*3	Word 23-26: Firmware revision; ASCII code (8 characters, Left-justified)
*4	Word 27-46: Model number;
	ASCII code (40 characters, Left-justified), remainder filled with blank code (X'20')
	One of three model numbers;
	MPC3045AH, MPC3065AH
*5	Word 49: Capabilities
	Bit 15-14: Reserved
	Bit 13: Standby timer value 1 = Standby timer values as specified in ATA standard are
		supported
	Bit 12:	Reserved
	Bit 11:	IORDY support	1=Supported
	Bit 10:	IORDY inhibition	0=Disable inhibition
	Bit 9:	LBA support	1=Supported
	Bit 8:	DMA support	1=Supported
	Bit 7-0: Vendor specific
*6	Word 51: PIO data transfer mode
	Bit 15-8: PIO data transfer mode			X'02'=PIO mode 2
	Bit 7-0:	Vendor specific

*7 Word 53: Enable/disable setting of word 54-58 ,64-70 and 88 Bit 15-3: Reserved

Bit 2: Enable/disable setting of word 88 1=Enable

Bit 1: Enable/disable setting of word 64-70 1=Enable

Bit 0: Enable/disable setting of word 54-58 1=Enable

*8 Word 59: Transfer sector count currently set by READ/WRITE MULTIPLE command Bit 15-9: Reserved

Bit 8: Multiple sector transfer 1=Enable

Bit 7-0: Transfer sector count currently set by READ/WRITE MULTIPLE without interrupt supports 2, 4, 8 and 16 sectors.

*9 Word 63: Multiword DMA transfer mode

Bit 15-8: Currently used multiword DMA transfer mode

Bit 7-0: Supportable multiword DMA transfer mode Bit 2=1 Mode 2

Bit 1=1 Mode 1

Bit 0=1 Mode 0

C141-E056-01EN 5 - 31