When one of following commands is issued, the command is executed normally and the device is still stayed in the standby mode.

Reset (hardware or software)

STANDBY command

STANDBY IMMEDIATE command

A command without accessing the drive

CHECK POWER MODE command

(4)Sleep mode

The power consumption of the drive is minimal in this mode. The drive enters only the standby mode from the sleep mode. The only method to return from the standby mode is to execute a software or hardware reset.

The drive enters the sleep mode under the following condition:

A SLEEP command is issued.

Issued commands are invalid (ignored) in this mode.

6.3.2Power commands

The following commands are available as power commands.

IDLE

IDLE IMMEDIATE

STANDBY

STANDBY IMMEDIATE

SLEEP

CHECK POWER MODE

6.4Defect Management

Defective sectors of which the medium defect location is registered in the system space are replaced with spare sectors in the formatting at the factory shipment.

All the user space area are formatted at shipment from the factory based on the default parameters listed in Table 6.1.

6 - 10

C141-E056-02EN

Page 169
Image 169
Fujitsu MPC3045AH, MPC3065AH manual Power commands, Defect Management