Fujitsu MPD3XXXAT manual 092

(3)Special jumper settings

(a)2.1 GB clip (Limit capacity to 2.1 GB)

If the drive cannot be recognized by system with legacy BIOS’s which do not allow single volume sizes greater than approximately 2.1 GB, the following jumper settings should be applied.

2 4 6 8 2 4 6 8 2 4 6 8

1	3	5	7	9	1	3	5	7	9	1		3	5	7	9
Master Device					Slave Device						Cable Select
Model					No. of cylinders				No. of heads			No. of sectors
MPD3043AT					4,092				16					63
MPD3064AT					4,092				16					63
MPD3084AT					4,092				16					63
MPD3108AT					4,092				16					63
MPD3130AT					4,092				16					63
MPD3173AT					4,092				16					63

(b)Slave present

If the slave device does not use the Device Active/Slave Present (DASP–) signal to indicate its presence, the device is configured as a Master with slave present when the following jumper settings is applied.

2 4 6 8

1 3 5 7 9

Slave present

C141-E069-02EN 3 - 15